0
0

Gesamt:€ 0.00

Siehe WarenkorbKasse
LoginRegister
0

Gesamt:€ 0.00

Siehe WarenkorbKasse
LoginRegister

Conntek GIB1450-025 Duo-Rain Seal 50-Ampere-Stromeingangsbox und Temp-Netzkabel-Kombi-Kit, 25 Fuß 25' Kabel

Brand:Conntek

3.8/5

€
431.73

Stromeingangskästen versorgen kritische elektrische Systeme mit Strom und vermeiden gleichzeitig die schädlichen Abgase, die ein Generator erzeugt. Montieren Sie die Box einfach an der Außenseite eines Hauses/Geschäfts und führen Sie die Verkabelung zu einer Transferschalter-/Boxinstallation. Wenn Notstrom benötigt wird, schließen Sie ein Generatorkabel an den Eingangskasten an und betätigen Sie den Schalter für die Übertragungseinheit. Diese Boxen sind mit einer SS2-50 (CS6375)-Steckerkonfiguration für große Systeme ausgestattet. 25FT 50Amp DUO-Rain Seal Kit Temporäres Netzkabel NEMA 14-50P Generatorstecker an CS-6364-Anschluss mit 50-Ampere-Anschlüssen Netzkabel werden unter Verwendung von 600-Volt-STW-Kabeln hergestellt. Bleibt bei kaltem Wetter flexibel und hitzebeständig bis 221 °F. Zulassung: Stecker, STW: UL, C-UL.

Keine Einheiten verfügbar

EAN: 0883943014859

Kategorien Patio, Rasen & Garten, Generatoren & Stromerzeuger, Generatorenzubehör, Kabel, Stecker & Adapter,

Maximale Leistung: 12.500 Watt. Verschlusskragen für verbesserten Schutz vor Witterungseinflüssen während des Gebrauchs. Einlassbox: CS6375- oder SS2-50P-Einlass. 4 Knockouts bei 0,85 Zoll. Ergo Grip-Steckergriff mit LED-Betriebsanzeigen und abgewinkeltem Stecker für verbesserte Zugentlastung. Temp-Netzkabel: NEMA 14-50P (4-polig) zu CS6364, 25 Fuß lang.
Brand Conntek
Color Black/grey
Connector Gender Male-to-Female
Country of Origin China
Customer Reviews 4.7 4.7 out of 5 stars 1,175 ratings 4.7 out of 5 stars
Input Current 50 Amps
Is Discontinued By Manufacturer No
Item model number GIB1450-025
Item Weight 23.4 pounds
Manufacturer Conntek
Product Dimensions 18 x 18 x 3 inches
Voltage 600 Volts

3.8

11 Review
5 Star
83
4 Star
12
3 Star
3
2 Star
1
1 Star
1

Schreiben Sie eine Bewertung

Ihre E-Mail wird nicht veröffentlicht. Alle Pflichtfelder sind mit gekennzeichnet*

Scritto da: adam ashby
Decent equipment for price
All in all , this product isn’t bad and I’d say it is worth the cost without a doubt. I am a master electrician (not bragging, only expressing where my experience comes from!) that has had to install many of different styles of generator and rv hookups. This product is on par with other direct distributors, and the unfortunate fact is all equipment is mass produced and “cheaply” made these days. But, my complaints with this product are minimal because of how much care and effort was put into the cord, this is where conntek excelled and where the majority of the value comes from. The only real issues are with the outdoor box and receptacle mount and are as followed: - there isn’t much room within the box for you’re #6/4 feed wires , so you’ll have to make sure you are exact with the length you cut them down to. - the metal used for the mounting box isn’t the best and slightly pliable , so make sure to pre-bend you’re wires to get the cover seated correctly. - you are going to run into an issue of landing the wires while the receptacle is mounted in the cover because of where the termination lugs sit. There isn’t enough room to get your Allen key into the lug, so it may be beneficial to detach the receptacle, install the cover, then land your wires , and then remount receptacle. - the weather proof door that protects the receptacle was bent slightly from manufacturer and will eventually cause a leak issue(as seen in picture) so make sure to grab some cheap gaskets before install just Incase. Again these issues aren’t deal breakers and can be rectified with a small amount of know how. If you are in need of a hookup definitely consider going ahead and buying this one. It gets the job done and comes with a well built cord and cord ends. LASTLY!!!! DO NOT INSTALL THIS UNIT WITHOUT ALSO BUYING A MAIN BREAKER GENERATOR INTERLOCK KIT!!! EVERY PANEL IS DIFFERENT AND REQUIRES A SPECIFIC TYPE AND IS DESIGNED FOR YOUR SAFETY AND TO ENSURE YOU DON’T BURN YOUR HOUSE DOWN. IT IS THE MOST IMPORTANT PIECE AND ANY ELECTRICAL SUPPLY HOUSE CAN POINT YOU IN THE RIGHT DIRECTION!! Sorry for the all caps but it is imperative that you buy and install this extra item, please do not skip on this. It is extremely dangerous without one. I have included an example of one in the pictures for reference when you are searching for one to fit your panel.
Scritto da: Douglas Amelio
Worked as intended
Scritto da: Bill Bellizzi
What Were They Thinking?
I bought this item because it looked like it was good quality, and because it came as a matched set. I didn't have worry about purchasing an inlet box that didn't match the power cord. In the reviews I saw a mention of space being tight for the wires, but that seemed like a minor issue. After installing the inlet box, I KNEW that space wasn't the issue. The issue was the interior DESIGN and the printed instructions. The instruction illustrations didn't look like the product I had, but I followed them thinking that everything would become clear as I did what the instructions said. First they said, "Cut an opening the hull using your 2 1/2 " diameter hole saw." Didn't know why they wanted such a large hole for 4 wires, but I followed the instructions. Then, "See the inlet flush in the hole you just drilled. Using the inlet as a guide, mark the mounting hole locations. Take out inlet and drill mounting holes using 1/8" drill bit." And then I discovered why I should not have done any of that. Here's the short version: For this installation you need four #6 wires. The inlet box has a 3/4" knockout that is below and to the left of the socket that holds the wires. This means that these stiff wires must be bent up, to the right, and then forward, to install into the socket. If this sounds difficult, you're right. I succeeded and then tried to push the cover onto the base to close the box. I thought I was almost done. Wrong. I was just getting started. I couldn't get the box shut because the wires were so stiff that I couldn't get the box shut. I had to drill a 3/4" hole directly behind the socket assembly and install a 3/4" bushing that would allow the wires to slide back into the hole as the cover was being installed. I was lucky to have a step drill to drill the hole for the wires. Lastly, there was a fitting on the inside of the box to attach the supplied ground wire. Seemed simple. This fitting was difficult to get the wire into, and, as I went to close the cover, the stranded wire started coming out and would not stay put. I wound up using a terminal lug to hold the wire and then fastened that to the fitting that was supposed to secure the ground wire. Then I was able to close the box as the wires easily slid backwards as I pushed the front cover forward. All of the hassle could have been avoided with accurate instructions, a knockout directly behind the socket, and a simple to use ground lug. What were they thinking? On a positive note, I liked that once the box was installed , you push the plug in, give it a little twist, and then screw a nut to hold it in place. I liked that. One last helpful hint. The cable plugs can be difficult to push in and twist. A little silicone spray can work wonders to facilitate pushing and twisting.
Scritto da: Michael E. Caudle
You Need an Electrician
This is a heavy duty Conntek unit is well built and, no doubt, will serve us well during periods of power outages. But, you will need a certified electrician to do the installment into your home. Unless you are an electrician, this isn't DIY project.
Scritto da: matthew starr
Nice Product - 4.5 stars
Very nice overall. Should have a bit more space for 6ga wires in my opinion, but doable, and perhaps easier for someone competent/practiced.
Scritto da: Jonathan
Very pleased
Worked perfectly with my setup and with the price was very cost friendly compared to other products i researched.
Scritto da: Amazon Customer
My electrician commented: very well built, excellent quality for the money
Had it installed by an electrician. He had no problem whatsoever punching the holes, connecting the 6-gauge wiring, closing the cover. It's tough because it's big wiring, nothing special. If you have trouble, perhaps you should take it as a sign you should not be doing it... just sayin'
Scritto da: Raymond S.
Installation pour génératrice de 12000watts.
Au sujet de la boîte d’entrée pour raccorder 4 fils no 6AWG la dimension de la boîte est trop petite beaucoup de misère pour fermer le couvercle et le câble d’alimentation c’est exactement ce que je voulait pour ma génératrice de 12000 watts merci.
Scritto da: Amazon Customer
Excellent produit
Branchement d'une génératrice. Excellent résultat. Toutefois l'extrême rigidité du fil rend difficile sa manipulation.
Scritto da: maxime leduc
Good product
Good product
Scritto da: philippe cunche
branchement de génératrice
bon prix et bonne qualité boitier un peu petit

Verwandte Produkte

hot
MaxWorks 80843 Beleuchtetes 10-Gauge-Generator-Verlängerungskabel, Schwarz/Gelb, mit L5-30P-Stecker und 3 15-Ampere-Ausgängen. 80843 – 3-poliger Drehverschluss, 15 Ampere
3.8/5

€ 117.14

MaxWorks 80843 Beleuchtetes 10-Gauge-Generator-Verlängerungskabel, Schwarz/Gelb, mit L5-30P-Stecker und 3 15-Ampere-Ausgängen. 80843 – 3-poliger Drehverschluss, 15 Ampere
3.8/5

€ 117.14

hot
VEVOR 30FT 50A Verlängerung STW 6/3 + 8/1 125V 250V UL-gelistetes Generator-Netzkabel N14-50P & SS2-50R & CS6364 Twist-Lock-Anschlüsse, schwarz
0.1/5

€ 291.94

VEVOR 30FT 50A Verlängerung STW 6/3 + 8/1 125V 250V UL-gelistetes Generator-Netzkabel N14-50P & SS2-50R & CS6364 Twist-Lock-Anschlüsse, schwarz
0.1/5

€ 291.94

hot
Conntek 30A 125V Marine Shore Power Cordsets Weiß 25 - Fuß
3.7/5

€ 121.71

Conntek 30A 125V Marine Shore Power Cordsets Weiß 25 - Fuß
3.7/5

€ 121.71

hot
10/4 50' STW 30A Generatorkabel, L14-30P/R 50 Fuß
3.8/5

€ 242.41

10/4 50' STW 30A Generatorkabel, L14-30P/R 50 Fuß
3.8/5

€ 242.41

hot
Reliance Controls PC3040 30 Ampere (L14-30), 40-Fuß-Generator-Netzkabel, schwarz
3.9/5

€ 225.00

Reliance Controls PC3040 30 Ampere (L14-30), 40-Fuß-Generator-Netzkabel, schwarz
3.9/5

€ 225.00

hot
Westinghouse Outdoor Power Equipment 30 Amp Inverter Generator Parallelkabel, 30 A 30 A Parallelkabel
3.6/5

€ 95.07

Westinghouse Outdoor Power Equipment 30 Amp Inverter Generator Parallelkabel, 30 A 30 A Parallelkabel
3.6/5

€ 95.07

hot
Conntek YL1430L1430 Y-Adapterkabel
4.1/5

€ 130.38

Conntek YL1430L1430 Y-Adapterkabel
4.1/5

€ 130.38

hot
Generac 6330 10 Fuß 50-Ampere-Generatorkabel mit NEMA 1450-Stecker und CS6364-Buchse mit Verriegelungsende, schwarz
3.8/5

€ 245.02

Generac 6330 10 Fuß 50-Ampere-Generatorkabel mit NEMA 1450-Stecker und CS6364-Buchse mit Verriegelungsende, schwarz
3.8/5

€ 245.02

Entdecken Sie unser internationales Netzwerk

Wir versenden in 28 Länder, über 200.000 Produkte. Bleiben Sie auf dem Laufenden, abonnieren Sie den Newsletter.

Array

Gesamt:€ 0.00

Siehe WarenkorbKasse

Kategorien

Alle Kategorien
Speisekarte Kategorien Nahe Wagen

Menu